ABBREE Flat SMA Male-to-Female Window Feedthrough Antenna Cable
Route Your Antenna Cable without Drilling
The ABBREE flat SMA male-to-female feedthrough cable is designed to route an antenna connection through a suitable window gap or door seam. Its slim, flat section offers an alternative to drilling a cable-entry hole when your installation has enough clearance.
For an indoor gateway connected to an outdoor antenna, choose the length that suits your route, check the connectors and gently test the window fit before completing the installation.
Key Features
- Flat pass-through design: intended for suitable window and door gaps where a round cable may be difficult to route.
- SMA male-to-female connection: threaded connectors for a matching antenna and equipment setup.
- Three length options: 30 cm, 60 cm and 1 m.
- Flexible protective covering: the existing specifications describe a heat-shrink outer jacket.
- RF antenna applications: suitable for consideration in compatible LoRa gateway, Helium miner and radio installations after checking electrical and connector requirements.
Specifications
- Brand: ABBREE
- Product type: flat coaxial antenna extension / window feedthrough cable
- Connector ends: SMA male to SMA female
- Available lengths: 30 cm / 60 cm / 1 m
- Approximate lengths in inches: 11.8 / 23.6 / 39.4 inches
- Outer covering: heat-shrink jacket, as described in the existing specifications
Choose Your Length
- 30CM: 30 cm for a shorter cable route.
- 60CM: 60 cm for additional routing flexibility.
- 1M: 1 m for a longer connection path.
Measure your route before ordering and avoid unnecessary cable length. Allow enough slack so that the connectors are not under tension.
Check Compatibility Before Ordering
Confirm that your antenna and equipment require the listed SMA male-to-female connection. Do not assume compatibility with RP-SMA, other connector types or every Helium miner, LoRa gateway or handheld radio.
The current specifications do not state impedance, supported frequency range, insertion loss, maximum power or flat-section thickness. If these values are critical to your installation, contact us to confirm them before purchasing.
Installation Guidance
- Check the available clearance before closing the window or door; do not force the cable into a tight seam.
- Avoid sharp folds, crushing and repeated flexing at the same point.
- Keep connectors free from strain and check the finished connection before use.
- Weatherproof exposed connections appropriately. No waterproof or ingress-protection rating is specified for this cable.
Frequently Asked Questions
Can I install it without drilling?
The flat design is intended for a suitable existing window or door gap. Fit depends on the clearance and seal design of your installation.
Will it work with my Helium miner or LoRa gateway?
Check the exact connector type and electrical requirements. The device category alone does not establish compatibility.
Does it use RP-SMA connectors?
This listing specifies SMA male-to-female, not RP-SMA. Check the center contacts and connector specification before ordering.
Will it boost antenna performance?
It is a cable-routing accessory, not an amplifier. RF cable connections can introduce signal loss; no measured insertion-loss value is provided.
Can it be left exposed outdoors?
No verified waterproof rating is listed. Protect exposed connections and confirm suitability for your intended environment.